Filter
Top Products
E-4 SunFastEthernet Adapter User Guide—November 1994
E
The driver cannot allocate sufficient memory for resources. These messages
occur when attempting to load the driver. You will be unable to load the driver
until sufficient memory becomes free. Terminating unnecessary processes or
unloading unused drivers are ways to free memory.
The values for the berpending and qerpending combined are too large. This
should not happen unless you try to adjust these values. Reduce the values
until the driver will load.
There is a resource shortage in the operating system most likely due to the
system being too busy. As a result, a received packet has been dropped. This
condition should be transitory.
The driver could not allocate enough receive buffers for the interface. The
interface will not be usable.
and
An invalid device unit number was passed into the specified routine. This
be<num>: bqeallocthings: Not enough system memory
be<num>: bqeallocthings: berpending and qerpending are too large
be<num>: bqeread: mbuf alloc failed
be<num>: beinit failed: out of buffers
be<num>: beinit: unit not on the list
be<num>: bestart: unit not on the list