Filter
Top Products
H8QG6/i+-F Serverboard User's Manual
2-24
After exiting the BIOS Setup Utility, the system will reboot. When prompted 4.
during the startup, press the <CTRL+A> key when prompted to run the Dot-
Hill RAID Utility program (see Figure 2-5).
Using the Adaptec RAID Utility
The Adaptec® RAID Utility program is where you can defi ne the drives you want
to include in the RAID array and the mode and type of RAID.
Figure 2-5.Adaptec RAID Utility Program Screen
Installing the RAID Driver During OS Installation
You may also use the procedure below to install the RAID driver during the Window's
OS installation:
With the Windows OS installation CD in the CD-ROM drive, restart the 1.
system.
When you see the prompt, hit the <F6> key to enter Windows setup.2.
Eventually a blue screen will appear with a message that begins "Windows 3.
could not determine the type of one or more storage devices . . ." When you
see the screen, hit the <S> key to "Specify Additional Device", then insert the
driver diskette you just created into the fl oppy drive.
Highlight "Manufuacturer Supplied Hardware Support Disk" and hit the 4.
<Enter> key.