Filter
Top Products
5-3
Chapter 5: Chassis Setup and Maintenance
5-4 Removing Nodes from the Chassis
Each of the eight individual nodes may be removed from the chassis. Note that
when a node is removed from the chassis, the hard drives located in the node will
shut-down.
Removing a Node
1. Power down the system and remove the power cords from the rear of the
node as described in Section 5-2.
2. Grasp the node by the handles on either side of the front of the node.
3. Carefully pull the node forward and out of the chassis.
5-5 Removing the Cover from the Node
Removing the Node Cover
1. Remove the power cord from the node as described in Section 5-2 and re-
move the node from the chassis as described in Section 5-4.
2. Remove the two screws on either side of the rear of the node.
3. Lift the cover up and off the node.
Figure 5-2: Removing the Node Cover
(Your node may differ slightly from the one shown in this illustration)