Filter
Top Products
MIL-BOOK™
OPERATORS MANUAL
- 2-4 -
2.3.3 Floppy Disk Drive/CD-ROM/DVD/COMBO/DVD RW
Bay 1 on the MIL-BOOK 1000 can contain either a removable floppy disk drive,
a removable CD-ROM, a removable DVD module or an auxiliary battery pack.
1. Turn the MIL-BOOK 1000 “Off”.
2. Open the Bay 1 access door. (See Fig 2-5)
3. Push down on the “Eject” handle at the bottom of the FDD/CD-ROM
/DVD/COMBO/DVD RW compartment. Then FDD/CD-ROM/DVD
/COMBO/DVD RW module will spring back about 0.4 cm.
4. Pull the handle outwards about 3 cm. Do not force it out any further as it
might damage the unit.
5. Using both hands, gently slide the entire FDD/CD-ROM/DVD/COMBO
/DVD RW module out form the bay 1 compartment.
2.3.3.1 Replace the FDD/CD-ROM/DVD/COMBO/DVD RW:
Using both hands, gently insert the FDD/CD-ROM/DVD/COMBO /DVD RW
module back into the bay 1 compartment. Continue to slide it in unit it seats
firmly in place. Be sure to closed and secure the bay 1 access door when not
in use. Turn the power back “On” to the MIL-BOOK 1000.
NOTE
Do not “Hot Swap” the FDD/CD-ROM/DVD/COMBO /DVD RW module. The MIL-
BOOK 1000 is not PnP (Plug and Play) ready.
Figure 2-5 Removing a FDD/CD-ROM/DVD/COMBO /DVD RW Module