Filter
Top Products
TANDBERG 7000 MXP
ii
CAUTION!
Avoid displaying the same images continuously over a long period
of time on the monitors.
Displaying the same images such as still images for a long time may cause after-image
lagging. This may occur in the following two cases:
1. After image lagging due to remaining electrical load
When image patterns with very high peak luminance are displayed for more than 1 minute,
after-image lagging may occur due to the remaining electric load. The after-images remaining
on the screen will disappear when moving images are displayed. The time for the after-images
to disappear depends on the luminance of the still images and the time they had been
displayed.
2. After-image lagging due to sticking
When images of the same pattern are displayed continuously for several hours or displayed
for a short period of time every day, after-images may remain on the screen due to the
sticking of the fluorescent materials. In this case, these images may decrease if moving
images are displayed after them, but basically they will not disappear.
Solving after-image lagging problems
If you have got after-image lagging on your monitors, you can reduce the problem to an
acceptable level by displaying a white image on the monitors for a few hours. This can be
accomplished by focusing the camera towards a white paper and setting maximum
brightness. See the ‘User Manual’ for details.
NOTE: Warranty may be invalidated if the precautions listed above are not followed.