Filter
Top Products
TANDBERG GW Data port Command Interface User Guide
14
4.2.2. General GW Commands
Command: Description:
Gateway
This command is used to configure the 3G gateway dialling rules, like for
example direct inward dialling, H323 call prefixes and dial in numbers. It is
possible to define 100 services, each with the parameters:
• Description indicates the user applied name of the service
• InNetType indicates the dial in for this particular service
configuration.
• OutNetType indicates the dial out for this particular service
configuration
• InPrefix will be used for matching the incoming called
number/address and is used to register with the gatekeeper in case
call type is H323
• InPostfix is the part of the dialed number that will be
removed/replaced.
• ServiceType indicates whether this service is a direct inward dialing,
a phonebook or an IVR service is.
• OutPrefix and OutPostfix will be used to construct the
number/address that will be called (if applicable) using this service.
Service [1..100] Description: <S: 0, 30>
or
Service [1..100] InNetType: <H324m/3G/H323 >
or
Service [1..100] OutNetType: <H324m/3G/H323 >
or
Service [1.. 100] InPrefix: <S: 0, 30>
or
Service [1.. 100] InPostfix: <S: 0, 30>
or
Service [1.. 100] ServiceType: < None/DiD/IVR/Phonebook >
or
Service [1.. 100] OutPrefix: <S: 0, 30>
or
Service [1.. 100] OutPostfix: <S: 0, 30>
or
LoadLimit: <0..100>
---
Parameters:
sub-commands:
• Description: This is a friendly name for the service configured like
for example 3G to H323 and 3G hotline to H323
• InNetType.
• OutNetType
• InPrefix.
• InPostfix
• ServiceType
• OutPrefix
• OutPostfix
• LoadLimit The GW will signal busy to the gatekeeper when the
current load on the GW reaches this limit. The current system load
can be monitored by the status command SystemLoad