Filter
Top Products
TANDBERG Video Portal Data port Command Interface User Guide
• User Commands, Xcom.
Parameter Configuration Commands
are commands that set a system parameter to a specific value. E.g.: The
command Xconf telnet mode: "on" enables telnet access on the Video Portal. If the command is syntactically
correct the Video Portal returns OK, otherwise the Video Portal returns ERROR. An example is shown below (the
user input is shown in bold).
Xconf telnet mode: "on"
OK
When issuing a Parameter Setting Command without a parameter, the Video Portal will return the command with
the current setting. E.g.:
Xconf telnet mode
*c xConfiguration Telnet Mode: On
OK
Status Commands
are commands that list different sets of system parameters. Status commands are automatically
called when corresponding parameters are being changed.
User Commands
are commands that allow users to configure operational parameters, like option keys, service and
dial plan entry manipulations, disk operations and system reboot.
4.2. The commands
The commands are divided into five groups: System Configuration Commands, General Video Portal Commands,
System Status Commands, Debug Commands and Special Commands.
D1392602 8