Filter
Top Products
17
Step-By-Step-Operation Guide
6
Mic level adjustment
Speak into the microphone. You will see
meter 1 move. Slowly push the channel 1
TRIM control until the meter peaks at no
more than "+6".
7 Beginning recording
Hold RECORD and press PLAY to initiate
recording. The REC indicator that was
blinking will turn on solid, indicating the
track is in Record mode.
8 Speak into the microphone.
9 Stopping recording
Press STOP (or PAUSE) to stop the tape
and finish recording.
10 Putting track into "Safe"
The track 1's REC indicator should now be
blinking as before. Set the RECORD
FUNCTION switch for track 1 to its SAFE
position.
‘
‘ ‘
Track 1 Playback through TAPE CUE
1 Selecting TAPE CUE
Set the EFFECT 2/TAPE CUE selection
switch located to the right of the track 4
meter to the right/TAPE CUE position.
2 Monitor selection
Press the lowest MONITOR switch on (the
switch marked EFFECT 2/TAPE CUE). The
other two MONITOR switches must be off.
3 Locating tape to zero
Set the ZERO RETURN switch to ON, then
press REW.
4 Beginning playback
Press PLAY.
5 MONITOR level control setting
Check to see that the MONITOR level
control is at the 12 o'clock position.
‘
‘
‘