Filter
Top Products
PMP200XL Models
Owner’s Manual
CAUTION
• The inverter is designed to operate from a 12-volt power source only. The unit
will not operate from a 6-volt battery or a 24-volt battery. Do not attempt
to connect the inverter to any other power nominal output voltage
other than 12 volts or damage to the unit may occur. Any damage
to the unit that occurs from operating the inverter from any power
source greater than or less than 12 volts will automatically void the
warranty.
• Do not attempt to extend or otherwise modify the 12-volt power cord attached
to the inverter.
• 110/120 volts can inflict serious injury, damage or death. Improper use of the
inverter may result in property damage, personal injury or loss of life.
Connecting the Inverter
The inverter is equipped with a fused 12-volt power cord for connection to the
power source.
1. Make sure that the ON/OFF power switch located on the front panel of
inverter is in the OFF(O) position.
2. Connect the inverter to the power source by inserting the 12-volt power cord
firmly into the cigarette lighter socket of your vehicle or other 12-volt DC
power source.
3. Turn the inverter power switch to the ON(-) position. The GREEN LED Indicator
Light should illuminate to confirm that power is running to the inverter.
4. Make sure that the device you intend to operate is turned OFF. Plug the cord
from the equipment into the AC outlet located on the front panel of the
inverter.
5. Turn the inverter power switch to the ON(-) position; then turn the
equipment ON.
Notes
• The audible alarm may make a momentary “chirp” when the inverter is turned
ON (-) or OFF(O). This same alarm may also sound when the inverter is being
connected to or disconnected from the 12-volt power source. This is normal.
• If the GREEN LED Indicator Light blinks when you first turn the inverter ON(-),
this may indicate an interruption of the power supply. Simply turn the inverter
OFF(O) and remove the 12-volt power cord from the cigarette lighter socket (or
other 12-volt power source). Firmly re-insert the 12-volt power cord, then turn
the inverter ON(-) again. If this does not fix the problem, try using a different
12-volt power source or check the cigarette lighter fuse.
3
Source of Power
Most automobile and marine batteries will provide an ample power supply to
the inverter for 30 to 60 minutes even when the engine is turned off. Actual time
may vary depending on the age and condition of the battery and the power
demand being placed on it by the equipment being operated.
If you decide to use the inverter while the engine is off, we recommend that
you start the engine every 30 to 60 minutes and let it run for approximately 10
minutes to recharge the battery. It is also recommended that the device plugged
into the inverter be turned OFF before starting the vehicle engine.
Although it is not necessary to disconnect the inverter when starting the vehicle
engine, it may momentarily cease to operate as the battery voltage decreases.
When the inverter is not supplying power, it draws very low amperage from the
battery. It is recommend that the inverter always be disconnected when not in
use.
Blown Automotive Fuses
Depending on the make and model of your automobile, running the power
inverter near full capacity from your cigarette lighter socket may result in a
blown automotive cigarette lighter fuse. This fuse will need to be replaced with
the same type and size fuse. A blown automotive cigarette lighter fuse will not
cause damage to your vehicle wiring.
Blown Inverter Fuses
Your power inverter is equipped with a 25-amp spade type fuse. With
reasonable care, it should not be necessary to replace this fuse. In general,
most blown fuses are the result of reverse polarity hook up of the inverter to a
12-volt power source (positive to negative and/ or negative to positive). If the
fuse happens to blow, disconnect the appliance or equipment from the inverter
immediately. Find the source of the problem, repair it and then install a new
fuse of the same type and size located on the rear panel of the inverter.
Note
Always disconnect the power inverter from the 12-volt power source and make
sure the inverter is turned OFF before replacing the fuse.
Safety and Usage Precautions
• For best operating results, place the inverter on a flat surface.
• Keep the inverter dry. Do not expose the inverter to rain or moisture.
• DO NOT operate the inverter if you, the inverter, the device being operated, or
any surface that may come into contact with the inverter are wet. Water and
other liquids can conduct electricity, which may lead to serious injury or death.
4
PMP200XL_122205M.indd 8-9 12/22/05 9:09:47 AM