Filter
Top Products
PMP200XL Models
Owner’s Manual
They will read about 20 to 30 volts too low. To accurately measure the output
voltage of the inverter, use a true RMS reading voltmeter such as a Fluke 87,
Fluke 8060A, Beckman 4410, Triplett 4200 or any voltmeter identified as a “true
RMS” modified sine wave.
In Review
• Never attempt to operate the inverter from any other power source other than
a 12-volt battery.
• The inverter is designed to be connected to the power source with the supplied
12-volt power cord. Do not attempt to modify the power cord in any way.
• When connecting and using the inverter, make sure that the inverter is
positioned far away from any potential source of flammable fumes or gases.
• Make certain that the power consumption of the equipment you wish to
operate is compatible with the capacity of the inverter. Do not exceed 200-
watts.
• When attempting to operate battery chargers, monitor the temperature of the
battery charger for approximately 10 minutes. If the battery charger becomes
abnormally warm, disconnect it from the inverter immediately.
• Use only 25 amp spade type fuses for the inverter.
• When operating the inverter with an automobile or marine battery, start the
engine every 30 to 60 minutes and let it run for approximately 10 minutes to
recharge the battery.
• In the event of a continuous audible alarm or an automatic shut down of the
unit, turn the inverter OFF immediately. Do not turn the inverter ON again until
the source of the problem has been identified and corrected.
• To avoid battery drain, always disconnect the inverter when not in use.
• Do not expose the inverter to rain or moisture.
• Avoid placing the inverter near sources of heat or in direct sunlight.
• While in use, make sure that the inverter is properly ventilated.
• For best operating results, make sure the unit is placed on a flat surface.
Note
If you would like to purchase battery clips for this inverter, they are available for
purchase through our Customer Service Department at: 1-888-231-4022
7
SPECIFICATION:
Max. Continuous Power ....................................................200 Watts
Surge Capability (Peak Power) ..........................................400 Watts
No Load Current Draw ............................................................<0.3A
Waveform ..........................................................Modified Sine Wave
Input Voltage Range ........................................................11-15 VDC
AC Receptacle ......................................... 110/120V AC 3 prong rounded
Fuse ................................................................ 25 amp (spade type)
Dimensions ............................................. 3.6”(L) x 4.1”(W) x 6.9”(H)
92(L) x 105(W) x 175(H) /mm
Weight ................................................................................ 1.144 lbs (0.52 kgs)
Power Cord Cable ............ 14 AWG (Black) with cigarette plug x 1 pc.
WARNING:
The wattage output from your 12 Volt power port may vary depending on the
make and model of your vehicle. Please check your owner’s manual.
Questions?
If you have any questions about this product, please contact our Customer
Service Department at (888) 231-4022, 9 AM to 5 PM EST, Monday through
Friday, or visit our website at www.colemanpower.com.
8
PMP200XL_122205M.indd 12-13 12/22/05 9:09:48 AM