Filter
Top Products
5. INSTALLING SOFTWARE DRIVERS)
TR-824 User’s Manual
15
3. Click the “+” in front of SCSI controllers. “Tekram TR-824 SATARaid Controller” should appear.
5.3 Windows ME Installation
5.3.1 New Windows ME Installation
The following details the installation of the TR-824 drivers while installing Windows ME.
1. Install the TR-824 controller card into your system.
2. Install Windows ME fully.
3. After installation, right-click on My Computer and select Properties from the popup menu.
4. In the System window, choose the Device Manager tab.
5. In the hierarchical display under Other Devices is a listing for PCI RAID Controller. Click PCI RAID
Controller then click Properties.
6. In the Properties window, choose the Driver tab then choose Update Driver and click Next.
7. Choose “Search for a better driver than the one your device is using now (recommended)” then click
Next.
8. Choose Specify Location then type “A:\tr824.inf” in the text box.
9. Insert the TR-824 driver diskette into the A:\ drive.
10. Click the Next button. A message informing you that “Tekram TR-824 SATARaid Controller”
should appear.
11. Click Next, then click Finish.
12. When asked if you want to restart your computer, click Yes. Immediately remove the diskette from
drive A:\.
5.3.2 Existing Windows ME Installation
The following section details the installation of TR-824 drivers on a system that has Windows ME already
installed and running.
1. After installing the TR-824 controller card and configuring the hard drives, power up the system and
boot.
2. The Add New Hardware Wizard will appear, informing you that it has found a PCI Mass Storage
Controller.
3. Click Next, then from the generated list box, choose Specify the location of the driver (Advanced).
4. Click Next, then from the generated choices, choose Specify a location.
5. Insert the TR-824 driver diskette in drive A:\.
6. Type “A:\tr824.inf” in the text box that appears.
7. Click Next. A message informing you that Windows Me has found “Tekram TR-824 SATARaid
Controller” should appear.
8. Click Next, then click Finish. When asked if you want to restart your computer, click Yes. Immediately
remove the diskette from drive A:\.
5.3.3 Confirming Driver Installation in Windows ME
To confirm that the driver has been properly loaded in Windows Me, perform the following steps:
1. Right-click the My Computer icon and select Properties from the popup menu.
2. Select the Device Manager tab.
3. Click the “+” in front of SCSI controllers. “Tekram TR-824 SATARaid Controller” should appear.
5.4 Windows NT4.0 Installation
5.4.1 New Windows NT4.0 Installation
The following details the installation of the TR-824 drivers while installing Windows NT4.0.
1. Start the system installation by booting from the Windows NT disk:
Floppy install: boot the system with the Windows NT installation diskettes.
CD-ROM disk install: boot from the CD-ROM disk and press <F6> when the message “Setup is
inspecting your computer’s hardware configuration…” appears.
2. When the Windows NT Setup window is generated, press <S> to Specify an Additional Device(s).
3. Select Other then press <Enter>.
4. Insert the TR-824 driver diskette into drive A:\ and press <Enter>.
5. Choose Tekram TR-824 SATARaid Controller for Windows NT 4.0 and 2000 from the list that