Filter
Top Products
Command Descriptions
Option 01 VXI Interface Module User Manual
3–21
[ROUTe:]CLOSe
:DWELl<module_name>,<nrf>
N/A
The close dwell time of all modules is set to 0 seconds.
The value of the time specified in this command must be between 0 and 6.5535
seconds.
[ROUTE:]CLOSe
[ROUTe:]SCAN
OUTPut:TTLTrg<n>[:STATE]
Set the time to wait after closing a relay before proceeding and pulsing any
enabled VXI TTL trigger signals.
In this example the Option 01 is installed on a VX4330 Module.
Command Response
output:ttltrg1:state
on
Enable VXI TTL trigger 1.
route:close:dwell
m1,.25
Set the close dwell time for the VX4330 to 0.25 seconds.
route:open:dwell
m1,0.5
Set the open dwell time for the VX4330 to 0.5 seconds.
route:close
(@m1(1!3:10!3))
Close relays 1 through 10 in section 3 of the VX4330, wait 0.25
seconds, then pulse VXI TTL trigger 1.
route:scan
(@m1(1!6:20!6))
Define a scan list consisting of relays 1 through 20 in section 6
of the VX4330.
trigger:Sequence:
source ttltrg2
Define VXI TTL trigger 2 as the trigger source for the defined
scan list.
trigger:sequence:
delay 1
Set the trigger delay time to 1 second.
initiate:immediate Initiate the scan sequence.
Command Syntax
Query Syntax
*RST Value
Limits
Related Commands
Description
Examples