Filter
Top Products
Command Descriptions
3–56
Option 01 VXI Interface Module User Manual
0
The time specified in this command must be between 0 and 6.5535 seconds.
ABORt, ROUTe:SCAN
TRIGger[:SEQuence]:SOURce
TRIGger[:SEQuence][:IMMediate]
TRIGger[:SEQuence]:DELay
This command specifies the time to wait after a trigger event is detectedbefore
opening the current relay in a scan list. A trigger event is enabled with teh
TRIGger:[SEQuence]:SOURce command.
Command Response
route:scan
(@m1(1,2),m2(1:64))
Define a scan sequence consisting of relays 1 and 2 on relay
module m1 and relays 1 through 64 on module m2.
trigger:sequence:count
2
Define the number of times to sequence through the scan list
before setting the state of the trigger subsystem back to the
idle state.
trigger:sequence:delay
0.5
Wait 0.5 seconds after a trigger event is detected before open-
ing the current relay in a scan list and closing the next relay in
the list.
trigger:sequence:
source ttltrg2
Sequence to the next relay in a scan list when VXI TTL trigger
2 is asserted.
initiate:immediate Initiate the scan sequence. Sequence through the entire scan
list two times. Wait 0.5 seconds after VXI TTL trigger 2 is as-
serted before sequencing to the next relay in the list.
TRIGger
[:SEQuence]
[:IMMediate]
N/A
N/A
N/A
*RST Value
Limits
Related Commands
Description
Examples
Command Syntax
Query Syntax
*RST Value
Limits