Filter
Top Products
Reference
18
PS280 & PS283 User Manual
5V FIXED 3A
-+GND
-+GND
SLAVE MASTER
Load 2 Load 1
–5 V
0 to +60 V
Figure 9: Independent Positive Stacked Application
To test a circuit in the independently stacked mode, follow these
steps:
1. Turn the POWER off to the PS280 or PS283.
2. Connect the outputs as shown in Figure 9.
3. Set both variable supply VOLTAGE controls to the minimum
setting.
4. Set both variable supply CURRENT controls to midrange.
5. Turn on the POWER to the PS280 or PS283.
6. Set the desired voltage. Observe the LED display; the total output
is the sum of both voltage readings.
7. Turn the POWER off to the PS280 or PS283 again.
8. Connect the device or devices to be tested.
9. Turn on the POWER to the PS280 or PS283 again. If necessary,
readjust the voltages.