Filter
Top Products
Section 1 Contents
OMEGA Installation, Operation, and Maintenance Manual 19
Figure 1-3. Connecting an Input Voltage Source
3.
Strip the wires that will be making contact with OMEGA from
.25 to .40 inches. Then connect the power supply source to the
3-position terminal block on OMEGA by connecting the hot,
neutral, and ground wires as follows:
- The hot and neutral wires should be on the fused right side.
- The ground wire should be on the left (green/yellow) side.
NOTE:
OMEGA has two 2A slo-blo fuses. To accesses the fuses, lift the
power connector handles as shown in Figure 1-3.
WARNING!
The ground wire between OMEGA and earth ground must be
as short as possible. Ensure that the ground wire makes
contact with earth ground.