CARE AND MAINTENANCE
Storage and Transportation
To prepare your P200/P250 for transport, perform the following steps:
1. Press
POWER
to turn off the projector and lamp. (The fans will
continue turning for approximately three minutes.)
2. When the fans have stopped turning and the P200/P250 is cool,
unplug the power cord.
3. Close the P200/P250 down to its storage position and engage the
locking mechanism.
4. Rotate and close the mirror into its storage position.
NOTE: Store and transport the Firefly
™
P200/P250 at temperatures
between 0° and 140°F (-17° to 60°C). Avoid storage in automobiles
during seasonal temperature extremes. Automobile interior
temperatures can exceed 160°F (70°C) in summer and drop below
-20°F (-29°C) in winter. If the Firefly
™
P200/P250 has been exposed to
extremely hot, cold or humid conditions, allow it to stand at room
temperature for 30 minutes before use. Take care to protect the Firefly
™
P200/P250 from jarring impacts.
Lens Cleaning
1. Lift and rotate the mirror as shown in Figure 6.
2. Gently wipe the exposed lens surfaces with a clean, lint-free tissue
(slightly moistened with lens cleaner if necessary). Never pour lens
cleaner or other solvents on the lens elements.
CAUTION! Never use silicone-impregnated eyeglass tissues on the
coated projection lens.
Lamp Replacement
1. Press
POWER
to turn off the projector and lamp. (The fans will
continue turning for approximately three minutes.)
WARNING! To prevent burns, allow the lamp access door and
projector lamp to cool before attempting to replace the lamp.
2. When the fans have stopped turning and the P200/P250 is cool,
unplug the power cord.
☞
User Manual 19