3. Rotate and lower the mirror, then close the P200/P250 down to its
storage position.
4. Turn the P200/P250 over on a flat, stable surface.
NOTE: Typically, lamps have an average operating life of approximately
30 hours. When lit,
REPLACE LAMP
indicates that the P200/P250 has
reached this average lamp operating life, and lamp failure may occur
soon. You may elect to replace the lamp or reset the
LAMP HOURS
using the Menu Mode On-Screen control, or you may elect to continue
using your P200/P250 until the lamp actually fails.
5. Loosen the two lamp compartment screws shown in Figure 12.
(These are captive screws and should not be completely removed.)
Retainer Clip
Spare Lamp
Active Lamp
Slide
Bulb
Out
Lamp
Compartment
Screw
WARNING:HOT
Allow unitto cool before
replacing lamp.Avoid
touching bulbor inside
of reflector.
Replace with FXL Lamp.
Lamp Compartment
Screw
Figure 12. Lamp Replacement
☞
20 User Manual