Filter
Top Products
3 SpeedTouch™ Web Interface
E-SIT-CTC-20030605-0003 v1.0
44
DHCP Click this link to display the Dynamic Host Configuration Protocol (DHCP) page.
This page allows you to:
• Click the DHCP Server tab to access the DHCP server page.
This page has three tabs:
• Click the Server Config tab to enable/disable the SpeedTouch™
(Auto)DHCP server:
Depending on the DHCP server status, following Status may be shown:
• Scanning for other DHCP server:
When the DHCP server and its Auto DHCP feature are enabled,
during local network probing on the SpeedTouch™ Ethernet interface
eth0.
• DHCP server stopped:
When the DHCP server and its Auto DHCP feature are enabled, and a
concurrent DHCP server was found during probing, thus causing its
own DHCP server to be stopped and a DHCP client on the
SpeedTouch™ Ethernet interface eth0 be created and activated.
• DHCP server started:
When the DHCP server and its Auto DHCP feature are enabled, and
no concurrent DHCP server was found during network probing, thus
starting its own DHCP server on the SpeedTouch™ Ethernet interface
eth0.
• DHCP server running:
When the SpeedTouch™ DHCP server is enabled by default (without
DHCP client)
• DHCP client:
When SpeedTouch™ server is disabled by default, and a DHCP client
is running on the SpeedTouch™ Ethernet interface eth0.
• No DHCP:
When the SpeedTouch™ server is disabled by default and the
SpeedTouch™ Ethernet interface eth0 IP address is statically assigned.