Filter
Top Products
Note: If you are going to wake to nature sounds, then the last nature
sound you listen to will be the same nature sound you wake to
when the alarm sounds, unless the controls are changed.
Alarm Operation
Important
• While setting the alarm times, if you do not press the appropriate buttons
(as explained below) within approximately 8 seconds the display will
stop flashing. If this happens you must follow the steps again from
step 1.
• While setting the alarm times, if you press and hold the µ ¸ FWD or
REV button the minutes will begin at a moderate pace, then get faster.
This will assist you in setting the time both fast and exact.
Setting the Alarm Time(s)
1. Press the ᕥ Alarm Set button until the Alarm Indicator that you wish
to wake to appears on the top of the display (
Weather, Sounds,
Buzzer) and the alarm time is flashing.
2. Press the µ ¸ FWD or REV button to set the correct alarm time.
REMEMBER to set the correct AM or PM. The PM Indicator is located
on the upper left side of the display.
3. Press the ᕩ 7•5•2 button to set the alarm for 7, 5, or 2 days a week.
The Days of the Week Indicators are located at the back of the
display.
4. Repeatedly press the ᕥ Alarm Set button until the display returns to
normal mode. A beep will confirm that the alarm time is set.
“Wake to” Operation
Wake to Instant Weather
1. Set the Instant Weather alarm time as indicated under Setting the Alarm
Time(s).
2. Follow the instructions under Listening to Instant Weather to tune into
the best weather station possible. The last ƿ Weather Band you
listen to will be the one you wake to when the alarm turns on unless
the controls are changed.
3. Adjust the ƾ Volume control to find the volume level that you wish to
wake to.
4. Press the ᕦ Weather button. The Weather Alarm Indicator will
appear on the top of the display. The weather alarm is set to turn on
at the time it is set for.