Filter
Top Products
Xplorer 870
Note: To save the settings, please select "Save Configuration" and then click "Save".
8.2 RFC 1483 Routed Mode
Select RFC1483 Routed Mode to change the router to function in RFC1483
Routed connection mode.
Parameters Description Default Value
VPI Virtual path identifier N/A
VCI Virtual circuit identifier N/A
Wan IP address Selected PVC's IP address N/A
Subnet Mask Selected PVC's Subnet Mask N/A
NAPT Network Address Port Translation ON
Consult your service provider for the related IP information for the WAN connection
including IP and Subnet Mask.
To set the VPI/VCI/WAN IP/WAN Subnet Mask parameters including adding,
modifying and deleting, refer to "Setup VPI/VCI " in Configure RFC 1483 Bridged
Mode.
NAPT should be enabled in this mode!
Note: To save the settings, select "Save Configuration" and then click "Save".
8.3 PPP over ATM and PPP over Ethernet
Select PPPoA Mode button to use PPP over ATM connection mode or PPPoE
Mode button to use PPP over Ethernet connection mode. Your Internet Service
Provider (ISP) will tell you the values of VPI/VCI to use after you sign up the service.
In Annex A of this manual you can find some country settings.
Setup WAN Connection
The Wan connection setup comes with the following parameters:
6666666666
HANDL. XPL 870 24/6/02 3:34 pm Pagina 66