Filter
Top Products
7/02, SatelliteToshiba TRR Page 12
Satellite 2400 Series Disassembly Overview
The information offered in this section is an overview of the Maintenance Manual, Chapter 4, Replacement
Procedures. If you have any questions or concerns regarding the proper procedure please refer to the Mainte-
nance Manual through the Toshiba Service and Support Website
before
you proceed.
To remove the battery, follow the steps below.
CAUTION: When handling battery packs, be
careful not to short circuit the terminals. Also
do not drop, hit or otherwise apply impact; do
not scratch or break the casing.
1. Turn the computer upside down.
2. Slide the battery latch to the left to
release it, then pull the battery cover
slightly forward and lift it out.
3. Lay the battery cover upside down. Push
the latches to the outside and lift out the
battery pack.
NOTE: For environmental reasons, do not
throw away a spent battery pack. Please follow
local ordinances or regulations for its disposal.
This section explains how to remove Field
Replaceable Units (FRUs). It may not be neces-
sary to remove all the FRUs in order to replace
one.
The chart is a guide to which FRUs need to be
removed in order to remove others. The section
numbers on the chart refer to the sections in the
Maintenance Manual, Chapter 4.
Always start by removing the battery pack, next,
optional items such as the optional PC card and
optional memory module, then follow the line on
the chart to determine which FRU you must
remove next in order to repair the one you think is
causing the computer to operate improperly.
To remove an optional PC card, follow the steps
below.
1. Turn the computer right side up.
2. Press the eject button for the PC card
you want to remove, it will extend slightly.
3. Press the button again.
4. Grasp the PC card and remove it.