Filter
Top Products
7/02, SatelliteToshiba TRR Page 22
Satellite 2400 Series Disassembly Overview, cont.
To remove the display mask, follow the steps below.
1. Remove two mask seals at the bottom
corners of the display assembly.
2. Remove two M2.5x6 flat-head screws.
3. Release twenty-one latches on the
display mask as follows:
• Five on the bottom
• Five on each side
• Six on the top
!
To remove the FL inverter board, follow the steps
below.
1. Remove one M2x4 flat-head screw
securing the FL inverter board.
2. Rotate the FL inverter board out and
disconnect the FL cable from CN1 on the
FL inverter board.
3. Disconnect the HV cable from CN2 on
the FL inverter board.
4. Remove the FL inverter board.
To remove the LCD module, follow the steps below.
1. Remove four masking seals that cover
the screws.
2. Remove four M2x4 screws securing the
LCD module.
3. Carefully rotate the top of the LCD
module out to access the LCD/FL cable.
4. Remove the tape securing the LCD/FL
cable.
5. Disconnect the LCD/FL cable.
6. Remove the LCD module.
7. Remove four silver super flat-head
M2x3 screws securing two metal
braces.
!
Images continued on the next page
!