Filter
Top Products
TOSHIBA
DISPLAY DURATION SET
<3 MIN> 30 MIN
>Δ/∇: CHANGE DATA
>ENTER:ACCEPT CHANGE
Press the 'up' or 'down' arrow key to move the marker between the two available idle mode
times. Press the ENTER key to save the change or press the MENU key to exit to the main
menu and discard the change.
Note: If any of the following conditions occur, the LCD-Idle Mode will be inhibited and the
LCD will remain on continuously:
1) The UPS has received an EPO command.
2) The UPS is in Battery-Discharge Mode.
3) A fault has been detected in the main unit.
4) The UPS is in an overload condition.
6.19.4 Run Switch Select
Press the MENU key to access the menu data screens and press the 'down' arrow key to
scroll to the “Run Switch Select” setting screen display:
RUN SWITCH SELECT
<LOCAL> REMOTE
>*F1: DATA SET MODE
>Δ/∇: PRV/NEXT SCREEN
Press the F1 key to display the following active adjustment screen:
RUN SWITCH SELECT
<LOCAL> REMOTE
>Δ/∇: CHANGE DATA
>ENTER:ACCEPT CHANGE
Press the 'up' or 'down' arrow key to move the marker between the two "RUN SWITCH"
selections Press the ENTER key to save the change or press the MENU key to exit to the
main menu and discard the change. (Must have Remote Control option.)
6.19.5 Serial Com Station Address
Press the MENU key to access the menu data screens and press the 'down' arrow key to
scroll to the “Serial Comm Station Address” setting screen display:
SER COM STATION ADDR
STATION ADDRESS: 31H
>*F1: DATA SET MODE
> Δ/∇: PRV/NEXT SCREEN
Press the F1 key to display the following active adjustment screen:
SER COM STATION ADDR
STATION ADDRESS: 31H
>Δ/∇: CHANGE DATA
>ENTER: ACCEPT CHANGE
4200FA CT/XT User’s Manual 55