Filter
Top Products
28
74 PAPER FEED ....................................................... 23
Feed paper through the mechanism
Technical settings
Your e-STUDIO60F is delivered with factory-default
settings. However, you may adjust it to meet your re-
quirements by changing the technical parameters.
v Only change the technical settings if prompted to
do so by authorised service personnel!
Press M, 29 and OK. Use / to select and modify
the desired parameter and press OK.
Technical data
General
Dimensions
(W×D×H)
460×397×190 mm
Weight approx. 8 kg
Power supply 220–240 V / 50–60 Hz
Power consumption
in stand-by mode
approx. 10 W
Memory 8 MB
Directory capacity 200 entries
Telephone
connection type
PSTN/PABX
Chip card ISO 7816-4
PC connection
Connection type USB slave 1.1
Operating systems Windows 98/2000/ME/XP
Scanner driver TWAIN/WIA
Scanner
Type CCD colour
Resolution 600×600 dpi
Scanning area 216×297 mm
Scanning width 206 mm
ADF capacity 10 sheets max.
Flatbed scanning
speed
b/w 10.5 seconds/page, colour
17.5 seconds/page
Printer
Type colour bubble ink-jet
Resolution 600×600 dpi
Printing speed b/w up to 9 pages/minute,
colour up to 5 pages/minute
Printing width 203.2 mm
Printing length b/w 284.3 mm, colour 279.1
mm
Paper dimensions width: 88.9–215.6 mm length:
127–431.8 mm
Fax
Fax type ITU T30, G3
Connection type PSTN/PABX
Dialling type DTMF
Modulation V17/V21/V29/V27ter/V34
Coding scheme MH, MR, MMR
Modem speed 33k6 bps
Resolution normal mode: 200×100 dpi
fine/photo mode: 200×200 dpi
super fine mode: 200×400 dpi
Disclaimer notice
The following notice sets out the exclusions and limi-
tations of liability of TOSHIBA TEC Germany Imaging
Systems GmbH (including its employees, agents and
sub-contractors) to any purchaser or user („User“) of
the e-STUDIO60F, including its accessories, options
and bundled software („Product“).
The exclusions and limitations of liability referred to in
this notice shall be effective to the fullest extent per-
missible at law. For the avoidance of doubt, nothing in
this notice shall be taken to exclude or limit TOSHIBA
TEC Germany Imaging Systems GmbH’s liability for
death or personal injury caused by TOSHIBA TEC
Germany Imaging Systems GmbH’s negligence or
TOSHIBA TEC Germany Imaging Systems GmbH’s
fraudulent misrepresentation.
All warranties, conditions and other terms implied by
law are, to the fullest extent permitted by law, excluded
and no such implied warranties are given or apply in re-
lation to the Products.
TOSHIBA TEC Germany Imaging Systems GmbH shall
not be liable for any loss, cost, expense, claim or dam-
age whatsoever caused by any of the following:
use or handling of the Product otherwise than in ac-
cordance with the manuals, including but not limited to
Operator’s Manual, Users’ Guide, and/or incorrect or
careless handling or use of the Product;