Filter
Top Products
7-1
7. LOADING THE RIBBON
EO1-33019
7. LOADING THE RIBBON
7. LOADING THE RIBBON
Fig. 7-2
Fig. 7-1
Print Head Block
Head Release Lever
Top Cover
3. Fit the protrusion of the guide wheel into the notch of the ribbon core (take-up side).
4. Pull the knob and set the ribbon core to the spring guide wheel.
Guide Wheel
Protrusion
Notch
Knob
Spring Guide Wheel
Ribbon Core
(Take-up side)
The printer is capable of printing in thermal transfer mode only.
1. Turn the power off and open the top cover.
2. Move the head release lever toward the front of the printer and raise the print head block.
WARNING!
Be careful when handling the print head as it becomes very hot.