Filter
Top Products
8-4
EO1-330019
8. LOADING THE PAPER
8. LOADING THE PAPER
13. Close the top cover, and then attach the supply cover to the supply holder unit. (Refer to section
6.2 INSTALLING THE SUPPLY COVER.) Paper loading is now complete.
Cutter type: Where a cutter is fitted load the paper as standard and feed it through the cutter module.
NOTE: When using the cutter, be sure to cut the backing paper between the labels. Cutting on
the label will cause the glue to stick to the cutter, which may affect the cutter quality and
shorten it's life.
Cutter Module
Paper Outlet
Paper
Batch type:
Fig. 8-9
Top Cover
Fig. 8-10
Strip type:
1 Strip the labels from the backing paper for about 200-mm from the top edge of the label roll.
2 First push the strip lever toward the printer to release the hook, and then pull the strip lever.
3 Pass the backing paper between the strip roller and the strip guide roller. After taking up any slack
on the paper, set the strip lever in position.
Strip Lever
Strip Guide Roller
Fig. 8-11
Backing Paper