Filter
Top Products
11-3
EO1-33006
11. GENERAL MAINTENANCE
11.3 REMOVING JAMMED PAPER
11.3 REMOVING JAMMED PAPER
1. Turn the power off.
2. Open the top cover.
3. Move the head release lever toward the front of the printer to raise the print head block.
4. Remove the ribbon and paper.
5. Remove the jammed paper. DO NOT USE any sharp implement or tool as these could damage the
printer.
6. Clean the print head and platen, then remove any further dust or foreign substances.
7. Paper jams in the cutter unit can be caused by wear or residual glue from label stock on the cutter. Do
not use unspecified paper in the cutter. If frequent jams occur in the cutter contact your Authorized
Service representative.
Fig. 11-4
Print Head Block
Top Cover
Head Release Lever
■ Cleaning the Cutter Unit
1. Press the cutter cover release lever to detach the cutter cover.
WARNING!
1. Be sure to disconnect the power cord before cleaning the cutter unit.
2. The cutters are sharp and care should be taken not to injure yourself when cleaning.
Fig. 11-5
Cutter Cover
Release Lever
Cutter Cover