Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33047
2.7 Setting an Operating Environment
E2-21
2.7.1 Parameter Setting
(Cont.)
(8) LCD Language Selection
This parameter is to choose a language in which the LCD message is
displayed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a language, press the [PAUSE] key.
(9) Auto Forward Wait Selection
This parameter is to choose whether to activate the Auto Forward Wait
function or not.
This function, used in the cut mode, automatically feeds the media
forward for about 17 mm if there is more than 1-second idle time after
printing, to prevent the top edge of the media from curling.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting an auto forward wait, press the [PAUSE] key.
<2>PARAMETER SET
LCD ENGLISH
[RESTART]
[FEED]
ENGLISH
ITALIAN
JAPANESE
SPANISH
DUTCH
FRENCH
GERMAN
<2>PARAMETER SET
FORWARD WAIT OFF
[RESTART]
[FEED]
FORWARD WAIT OFF
Not activated
FORWARD WAIT ON
Activated
NOTES:
1. If the printer is not used for a few
days, the top edge of the media
may become curly, which may
cause a paper jam. The Auto
Forward Wait Function prevents
this problem since the media feed
amount is increased so that the
media stops past the platen.
2. When the Stop Position Fine
Adjustment Value is set in +
direction, the media will stop past
the media outlet.
When the value is set in –
direction, the media will stop
inside the media outlet.
3. This setting will be useful to fine
adjust the cut position of labels.