Filter
Top Products
2. PRINTER SETUP
ENGLISH VERSION EO1-33035
2.7 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities
E2-10
2.7.2 Self Print Test and
Dump Mode (Cont.)
Print test label sample
The test print contents should be changed by the following commands
and parameters:
PROGRAM VERSION: VX.XX XXXX ---Firmware version and checksum
TONE ADJUST: +XX --------------------------Print tone fine adjustment value
FEED ADJUST: +XX.Xmm-------------------Print position fine adjustment value
CUT POSITION ADJUST: +XX.Xmm ------Cut position fine adjustment value
BACKFEED ADJUST: +XX.Xmm-----------Back feed amount fine adjustment value
PARAMETER: [PC-850][0] -----------------Character code selection and Font “0”
selection
[9600][8][1][NONE][0] Baud rate, Data length, Stop bit length,
Parity, and Transmission control of RS-
232C
[ON][AUTO][FEED][B0] Forward feed wait function, Control code,
Feed key function, and Euro code
X-COORDINTE ADJUST: +XX.Xmm------X-coordinate fine adjustment value
SENSOR: TRANSMISSIVE [17]-------------Sensor selection and sensitivity
MEMORY: [192KB][XXXKB]---------------Memory capacity of the Main PC Board and
optional memory card (0,1,2,3,4,6,8)
TTF AREA: [XXXKB][XXXKB] ------------True type font storage area, Main PC board
and optional memory card
EXT CHAR AREA: [XXXKB][XXXKB]---Writable character storage area, Main PC
board and optional memory card
BASIC AREA: [XXXKB][XXXKB]---------BASIC file storage area, Main PC board and
optional memory card
PC SAVE AREA: [XXXKB][XXXKB] -----PC save storage area, Main PC board and
optional memory card
INFORMATION:--------------------------------Printed only when some information is
stored in the flash ROM
TOTAL FEED------------------------------------Total feed distance
PRINTER INFO.
PROGRAM VERSION VX.XX XXXX
TONE ADJUST +XX
FEED ADJUST +XX.Xmm
CUT POSITION ADJUST +XX.Xmm
BACKFEED ADJUST +XX.Xmm
PARAMETER [PC-850][0]
[9600][8][1][NONE][0]
[ON][AUTO][FEED][B0]
X-COORDINATE ADJUST +XX.Xmm
SENSOR TRANSMISSIVE [17]
MEMORY [192KB][XXXKB]
TTF AREA [XXXKB][XXXKB]
EXT CHAR AREA [XXXKB][XXXKB]
BASIC AREA [XXXKB][XXXKB]
PC SAVE AREA [XXXKB][XXXKB]
INFORMATION XXXXXXXXXXXXXXXXXXX
TOTAL FEED X.XXKm
NOTE:
The following commands should
not affect the test print issue.
D
, AX, XS, Z2;1, Z2;2 (without
A
Y)