Filter
Top Products
1 BEFORE USING EQUIPMENT
14 Placing Paper
10
Push the drawer straight into this equipment carefully until it comes to a stop.
Be careful not to let your fingers be caught when pushing the drawer into this equipment.
This could injure you.
6
Place paper in the drawer.
y Up to 550 sheets (64 g/m
2
) (17 lb. Bond) can be placed in one
drawer. Be sure that the height of the stacked paper does not
exceed the line indicated inside of the side guides.
P.11 “Acceptable copy paper”
y Fan and jog the stack of paper well before you place it in a
drawer, or the sheets may not be separated before being fed.
Be careful not to cut your fingers when fanning.
y Place paper with its copy side down. The copy side may be
noted on its wrapping paper.
7
Adjust the side guides.
Make sure that a gap (“A” in the figure on the right) of 0.5 mm (0.02")
(1.0 mm (0.04") or less in total)
*1
is left between the paper and the side
guide for plain paper. If the gap is inappropriate, it could cause paper
misfeeding.
*1 For thick paper, the gap must be 0.5 mm (0.02") to 1.0 mm (0.04") (1.0 mm
(0.04") to 2.0 mm (0.08") in total).
8
Push the part shown with an arrow (left side) to lock
the side guide.
9
Change the paper size indicator if required.
A