7. CASHIER KEY OR CASHIER SIGNING OPERATIONS
EO1-11095
7-3
7.2 CASHIER KEY METHOD (Hardware Option)
4
Light to indicate
ON-status
1 2 3
7.2 CASHIER KEY METHOD (Hardware Option)
When the [LOG/RECEIPT] (or [LOG]) key is not installed, the Push-stay Cashier Keys may be provided at the
side of the Mode Lock:
Push-stay Cashier Locks and Keys
Cashier Locks 1 to 4 Cashier keys 1 to 4
Each key is assigned to each cashier. The register will not operate in the “REG”, “MGR”, or “ - ” mode unless
one of these keys is inserted and pushed on or pushed-and-locked at the corresponding Cashier Lock. The light
is lit when the key is in the ON-status.
Each of the keys may be inserted and pulled out in the neutral position marked with “1” to “4” in the above figure,
and two ways are provided to set the Cashier Key to ON status:
PUSH-ON
When simply pushed on and released,the Cashier Key is set to ON status. This ON condition will be cleared by
any of the following conditions:
1) when no key-in operations follow in three seconds.
2) when the transaction is finalized.
3) when another Cashier Key is pushed-on when outside a sale.
4) when the Mode Lock is turned to another position.
PUSH-AND-LOCK
When pushed and turned to the right, the ON status is locked until it is turned back to release and another
Cashier Key is set to ON.
When another Cashier Key is attempted to push-and-lock, the register will entirely be locked.
If a Cashier Key has already been set to ON and a sale is under way, another Cashier Key will be disregarded
if attempted to ON.
Under the CASHIER KEY METHOD, no receipts are issued, nor will the drawer open by setting a cashier key to
the ON status.
The multi-drawer feature may be taken with the Push-stay Cashier Keys. In this case, the drawers 1 and 2 are
assigned to the cashiers of Cashier Keys 1 and 2. No drawers are assigned to the cashiers of Cashier Keys 3
and 4.
The “SIGN ON” triangular lamp will not be lit in any occasion under the CASHIER KEY METHOD.
The light attached to each Cashier Lock will be lit instead.