Filter
Top Products
8. INSTALLING AND REPLACING THE RECEIPT AND JOURNAL ROLLS
EO1-11149
8.2 Installing/Replacing the Journal Roll
8- 2
5. Insert the paper end into the receipt inlet behind the
printer. Then, manually feed the paper into the
printer while pressing the
[RF]
key until about 4
inches (about 10cm) of paper comes out of the
printer.
6. First pass the paper through the Receipt Outlet of the
Printer Cover, then attach the Printer Cover. After
that, depress the
[#/NS]
key to check the print
condition and cut the paper with the cutter.
CAUTION: Be sure to attach the Printer Cover to the
Top Cover tightly.
8.2 Installing/Replacing the Journal Roll
1. When replacing the journal, depress the
[JF]
key to
wind up the enough Journal Paper, then cut the
paper at the arrow indicating position in the figure on
the left. Press down the
[JF]
key to take away the
cut paper.
CAUTION
: Never try to pull out the remaining paper
end by hand. It may cause a paper jam.
2. Remove the Journal Take-up Reel Ass’y from the
holder, then remove the Support Plate (
) to pull the
paper out of the reel ( ).
3. Follow Steps 3 to 5 of “Installing/Replacing the
Receipt Roll” except that the paper roll should be
placed right holder and the [JF] key should be used
for the journal roll to advance about 8 inches (20 cm)
of paper out of the printer.
RF#/NS JF
X/TIME
987
C
RF#/NS JF
X/TIME
987
C
2
1