Filter
Top Products
Users Manual 8-10
Optional Devices
An external analog monitor can be connected to the computer's external
monitor port, with the computer supporting WUXGA video mode. In order to
connect a monitor, follow the steps as detailed below:
1. Turn the computer's power off.
2. Connect the monitor cable to the external monitor port and tighten the
screws on the left and right hand side of the connector as required.
Figure 8-6 Connecting the monitor cable to the external monitor port
3. Turn the external monitors power on.
4. Turn the computer's power on.
When you turn on the power, the computer will automatically recognize the
monitor and determine whether it is a color or monochrome device. If you
have problems on getting an image displayed on the correct monitor, you
should use the FN + F5 hot key to change the display settings (if you then
disconnect the external monitor before you turn the computer's power off,
be sure to press FN + F5 hot key again to switch to the internal display).
Please refer to Chapter 5, The Keyboard, for further details on using hot
keys to change the display setting.
The Video data on your computer can be viewed on a TV set. To do so,
connect your computers HDMI out port to the TV using the HDMI out
cable.
You can use the hotkeys FN + F5 to change the display device. Refer to
Chapter 5, The Keyboard.
Do not disconnect the external monitor while in Sleep or Hibernation Mode.
Turn off the computer before disconnecting the external monitor.