Filter
Top Products
4 Replacement Procedures 4.9 Optical disk drive (DVD-ROM/DVD-Super Multi drive)
4-36 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the Optical disk drive
To install the Optical disk drive, follow the steps below and refer to Figure 4-17 to 4-19.
NOTE: When installing a new optical disk drive, set the ODD bezel to the optical disk
drive while securing the latches.
1. Set the ODD rear bracket to the optical disk drive and secure them with the
following screws.
• M2.0×3C BIND screw ×2
2. Insert the optical disk drive assembly into the slot to connect it to the connector on
the system board.
3. Turn over the computer and secure the optical disk drive assembly with the following
screw.
• M2.5×5B FLAT HEAD screw ×1
ODD bezel
Optical disk drive