Filter
Top Products
4 Replacement Procedures 4.17 Jack/3G/Express board/Microphone/3G card
4-62 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the Jack/3G/Express board/Microphone/3G card
To install the jack/3G/Express board/microphone/3G card, follow the steps below and refer
to Figure 4-33 to 4-35.
1. Insert the 3G card to the connector on the jack/3G/Express board slantwise.
2. Push down the 3G card and secure it with the following screws.
• M2.0×3C BIND screw ×2
3. Connect the microphone harness to the connector CN6070 on the jack/3G/Express
board.
4. Connect the jack/3G/Express board FPC to the connector CN9630 on the
jack/3G/Express board.
5. Set the jack/3G/Express board (with the microphone) to the base assembly.
NOTE: When replacing a jack/3G/Express board with a new one, stick the gasket on the
jack/3G/Express board in place.
6. Set the microphone into the slot of the base assembly.
7. Connect the speaker harness to the connector CN6150 on the jack/3G/Express board.
8. Connect the jack/3G/Express board FPC to the connector CN9530 on the system
board.