Filter
Top Products
4 Replacement Procedures 4.12 Cover assembly and Base assembly
4-46 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Installing the Cover assembly and Base assembly
To install the cover assembly and base assembly, follow the steps below and refer to Figure
4-22 to 4-26.
1. Place the cover assembly on the base assembly and secure them with the following
screws.
• M2.5×8B FLAT HEAD screw ×5
• M2.5×12B FLAT HEAD screw ×3
2. Turn up the insulator (LCD CONN INSULATOR) and connect the LCD harness to
the connector CN5300 on the system board.
NOTE: Arrange the LCD harness under the guides.
When replacing the cover assembly with a new one, stick the insulator (LCD
CONN INSULATOR) to the system board in place.
When sticking the LCD CONN INSULATOR, set the cushion of the LCD CONN
INSULATOR on the connector of the LCD harness.
3. Connect the FS board FFC and camera harness to the connector CN9550 and
CN9540 on the system board.
LCD harness
Guide
Guide
Guide