Filter
Top Products
4 Replacement Procedures 4.13 North Bridge Thermal Module
4-46 Equium A60/ Satellite A60/ Pro A60/ A65 Maintenance Manual
8. Remove two pieces of sticky Mylar securing the MDC cable.
9. Disconnect the MDC cable from CN500 on the system board.
10. Remove the MDC cable.
MDC cable
CN500
Mylar
Figure 4-31 Removing the MDC cable
Installing the Removing North Bridge thermal module and MDC cable
Install the Removing North Bridge thermal module according to the following procedures and Figure
4-30, 4-31.
1. Place the MDC cable in the correct position...
2. Connect the MDC cable from CN500 on the system board.
3. Stick two pieces of sticky Mylar securing the MDC cable.
4. Connect the North Bridge thermal module cable to the CN15 on the system board.
5. Place the North Bridge thermal module in the correct position.
6. Secure the two washers and M2x3 black bind screws.
7. Place the CD tray in the correct position.
8. Secure the one M2.5x2.5 white bind screws.