Filter
Top Products
9-8 User’s Manual
Troubleshooting
LCD panel
Apparent LCD problems may be related to the computer's setup.
Solid State drive
Recovery Media Creator
Problem Procedure
No display Press hot keys Fn + F5 to change the display
priority, to make sure it is not set for an external
monitor.
Problems above remain
unresolved or other
problems occur
Refer to your software’s documentation to
determine if the software is causing the difficulty.
Run the diagnostic test.
Contact your dealer if the problems continue.
Problem Procedure
Computer does not boot
from hard disk drive
There may be a problem with your operating
system files. Refer to your operating system
documentation.
Problem Procedure
The Recovery Media
Creator can not be
launched because there
is no recovery partition.
You will see this message if you have previously
chosen to remove the partition and are trying to
create "Recovery Media". When there is no
recovery partition, the Recovery Media Creator
cannot make Recovery Media. However, if you
have already created a "Recovery Media", you
can use it to restore the recovery partition.
Simply follow the instructions in "Restoring the
preinstall software from your creating Recovery
Media" section in this manual. You will be
directed to select "Restore Original Factory
Image" from the drop-down menu. If you have
not created "Recovery Media", please contact
your dealer.