Filter
Top Products
52
Getting Started
Adding memory (optional)
Avoid touching the connector on the memory module or on the
computer. Grease or dust on the connector may cause memory
access problems.
9 Carefully remove the new memory module from its antistatic
packaging, without touching its connector.
10 Locate an empty memory module slot on the underside of the
computer.
If no memory slot is available, you must remove a module by
performing steps 2-3 of “Removing a memory module” on page 55.
For this model, Slot A is the slot on the right-hand side of the
memory compartment, when looking from the front of the computer.
Slot B is the slot on the left-hand side. If only one memory module is
to be installed, it must be installed in Slot A.
11 Pick up the memory module by its sides, avoiding any contact
with its connector. Position the module toward the socket,
aligning the connector’s notch with the matching key in the
socket.
(Sample Illustration) Aligning the memory module with the socket
NOTE
NOTE
latch
latch
key
notch
connector