Filter
Top Products
Operation28
English
Adjusting the volume
The speaker volume can be adjusted when an audio signal is being input.
Correcting keystone
Keystone distortion refers to the situation where the projected image is noticeably
wider at either the top or bottom. It occurs when the projector is not perpendicular
to the screen.
To correct this:
1. Adjust the position of the projector.
2. Press the AUTO button on the remote control or the projector.
If the image is still distorted, you will need to manually correct it following steps.
• Press the MEMU button on the projector or the remote control. Go to the Image
adjustment --> Keystone menu and adjust the values by pressing 3 /
4 button on the projector or remote control.
For example,
Switching input signals
The projector can be connected to multiple
devices at the same time. To sequentially select
input sources, press the INPUT button on the
projector control panel or the remote control. The
selected input signal will be displayed at the
upper left corner of the screen for 5 seconds.
0
Keystone
-6
Keystone
0
Keystone
+6
Keystone
Press the 3 button on the
projector or remote control when
you are in the Image adjustment -
-> Keystone menu.
----------------------------------------------->
Press the
4 button on the
projector or remote control when
you are in the Image adjustment --
> Keystone menu.
---------------------------------------------->