Filter
Top Products
21/27 XM-7002B Rev.1.0
7. Power Requirements
7.1. Source Voltage +5 V +/-5 % (Operating)
7.1.1 Spike 100 mV (p-p) Max
7.1.2 Ripple 100 mV (p-p) Max
7.2. Current Drain (Typ. Value)
7.2.1. Sleep(Minimum Current Mode) 0.025 A
7.2.2. Standby(Laser off,motor off) 0.03 A
7.2.3. Idle(Laser on,motor on) 0.32 A
Start Position
7.2.4. Continuous Read(Audio/Data) 0.62 A (Max.24X) / 0.35 A (Max.10X)
Start Position
7.2.5. Average(20% Duty Random Access) 0.64 A (Max.24X) / 0.34 A (Max.10X)
7.2.6. Maximum(100% Duty Random Access) 0.76 A ( Max.24X) / 0.44 A (Max.10X)
7.2.7. Peak in executing Access 1.4 A
(With out Spike Current*)
7.2.8. Peak Current 1.5 A
(With out Spike Current)*
*Spike:Less than 1ms width current
8. Audio
8.1. Line Output ----- in case of the attenuator is set at 0 dB by the command -----
(1) Output Level 0.775 V (rms Typ)+/- 3 dB
(2) Type Unbalanced
(3) Output Impedance 2.2 kOHM
(4) Load Impedance 47 kOHM
(5) Frequency Response 20 Hz to 20 kHz +/- 3.0 dB.(at 47 kOHM Load)
(6) Distortion 0.03 % Max. (at 1 kHz weighted 20 kHz LPF)
(7) Signal to Noise Ratio 78 dB Typ (IEC 179 A-weighted)
8.1.1. Audio Cable Unbalanced and shielded
(1) Capacitance Less than 1000 pF
(2) Length Max. 3 m