Syntax
storm-control multicast
no storm-control multicast
Parameter
rate —— Specify the bandwidth for receiving multicast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. The value of it can be
128k | 256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default,
the value is “128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the multicast control function for port 5:
TL-SG2424(config)# interface gigabitEthernet 1/0/5
TL-SG2424(config-if)# storm-control multicast
For TL-SG2452:
Description
The storm-control multicast command is used to enable the multicast control
function. To disable the multicast control function, please use no storm-control
multicast command. Multicast control function allows the switch to filter
multicast in the network. If the transmission rate of the multicast packets
exceeds the set bandwidth in the storm-control rate
, the packets will be
automatically discarded to avoid network broadcast storm.
Syntax
storm-control multicast
no storm-control multicast
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the multicast control function for port 5:
TL-SG2452(config)# interface gigabitEthernet 1/0/5
TL-SG2452(config-if)# storm-control multicast
94