Filter
Top Products
ip address
Description
The ip address command is used to configure the system IP address, Subnet
Mask and Default Gateway. To restore to the factory defaults, please use no ip
address command. This command should be configured in the Interface
Configuration Mode of the management VLAN.
Syntax
ip address {ip-addr} {ip-mask} [gateway]
no ip address
Parameter
ip-addr —— The system IP of the switch. The default system IP is 192.168.0.1.
ip-mask —— The Subnet Mask of the switch. The default Subnet Mask is
255.255.255.0.
gateway —— The Default Gateway of the switch. By default, it is empty.
Command Mode
Interface Configuration Mode (interface vlan)
Example
Configure the system IP as 192.168.0.69 and the Subnet Mask as
255.255.255.0 when the management VLAN of the switch is VLAN1:
TL-SG2424(config)# interface vlan 1
TL-SG2424(config-if)# ip address 192.168.0.69 255.255.255.0
ip address-alloc dhcp
Description
The ip address-alloc dhcp command is used to enable the DHCP Client
function. When this function is enabled, the switch will obtain IP from DHCP
server. This command should be configured in the Interface Configuration Mode
of the management VLAN.
Syntax
ip address-alloc dhcp
Command Mode
Interface Configuration Mode (interface vlan)
73