Filter
Top Products
27
state
[Enable | Disable]
I Use the state
interface
configuration
command to specify
the state mode of
operation for Ethernet
ports. Use the disable
form of this command
to disable the port.
switch(config)#interface
fastEthernet 2
switch(config
-if)#state Disable
show interface
configuration
I show interface
configuration status
switch(config)#interface
fastEthernet 2
switch(config-if)#show interface
configuration
show interface status I show interface actual
status
switch(config)#interface
fastEthernet 2
switch(config
-if)#show interface status
show interface
accounting
I
show interface statistic
counter
switch(config)#interface
fastEthernet 2
switch(config
-if)#show interface
accounting
no accounting I Clear interface
accounting information
switch(config)#interface
fastEthernet 2
switch(config-if)#no accounting
Trunk Commands Set
Commands Level
Description Example
aggregator priority
[1~65535]
G Set port group system
priority
switch(config)#
aggregator priority
22
aggregator activityport
[Group ID]
[Port Numbers]
G Set activity port switch(config)#aggregator
activityport 2
aggregator group G Assign a trunk group switch(config)#aggregator group