Filter
Top Products
26
5.3 Calibrating Media Sensor by Diagnostic Tool
5.3.1 Auto Calibration
1. Make sure the media is install ready and print head mechanism is closed. (Please refer to
section 3.3.)
Note: The media sensor position is moveable. Please make sure the gap (▽) or black
mark is at the location where media gap/black mark will pass through for
sensing.
Gap sensor
Black mark sensor
2. Turn on the printer power switch.
3. Open Diagnostic tool and set interface. (The default setting is USB.)
The default interface setting is
USB interface. If USB interface
is connected with printer, no
other settings need to be
changed in the interface field.
4. Click the “Calibrate Sensor” button.
5. Select the media type and click the “Calibrate” button.
1
2
1
2