Filter
Top Products
7
3.3 Loading Label Stock
1. Insert a 1” label spindle into a paper roll ( * If your paper core is 1 inch, remove
the 1.5” core adapter from the fixed tab. If label width is 4 inch wide, two fixing
tabs are not required. ).
Fig. 6 Label roll installation (I)
2. Open the printer’s top cover by releasing the green top cover open levers
located on each side of the printer and lifting the top cover. A top cover support
at the rear of the printer will hold the printer top cover open.
Fig. 7 Pull the lever to open the cover
3. Place a roll of paper onto the center of the paper roll mount.
4. Feed the paper, printing side face up, through the Teflon bar and the paper
guide and pass over the platen.
5. Adjust the green center-biased paper guides to slightly touch the edges of the
label backing.
6. To close the printer top cover, lift the cover to the ultimate open angle then use
Paper Roll
1” Label Spindle
Printing Side
Face Up
1.5” Core
Adapter*
Fixed Tab
Lower Cover