Filter
Top Products
Tiger i7320 S5350 Chapter 4: SATA/RAID Setup (for SATA RAID model)
4-4
http://www.tyan.com
4.5.4 Reset RAID Data
Note
Please refer to Section 4.7 for illustration examples of the Intel RAID
Option ROM windows.
Warning
All data on the RAID drives and any internal RAID structures will be lost.
1. Select option 3 Reset Disks to Non-RAID and press the <Enter> key to delete the RAID set
and remove any RAID structures from the drives.
2. Confirm the selection by pressing the <Y> key.
4.6 Loading the Intel Application Accelerator RAID Edition Driver
During Operating System Install
1. As Windows* Setup begins, press <F6> to specify the RAID driver.
2. When queried by the installation screen, press <S> to specify an additional device.
3. Insert the floppy disk labeled Intel Application Accelerator RAID Edition Driver and press
<Enter>. (The following four files should be on this disk: IASTOR.INF, IASTOR.SYS,
IASTOR.CAT, and TXTSETUP.OEM)
4. Press <Enter> to select the Intel RAID Controller.
5. Press <Enter> to continue with Windows Setup.
4.6.1 Instructions on Creating F6 Floppy Diskette
To create an F6 floppy diskette that contains the files that are needed when installing the
driver via an F6 installation method, complete the following steps:
1. Download the Intel Application Accelerator RAID Edition (or use the CD shipped you’re your
motherboard which contains the Intel Application Accelerator RAID Edition).
2. The following four files need to be copied from the compressed .CAB file (which is
contained inside the Intel Application Accelerator RAID Edition .EXE package):
IASTOR.INF, IASTOR.SYS, IASTOR.CAT, and TXTSETUP.OEM.
3. To extract these files, run 'C:\SETUP.EXE -A -P C:\<path>' (as described in the ‘Advanced
Installation Instructions’ section of the README.TXT.)
4. Once these files have been extracted, copied the IASTOR.INF, IASTOR.SYS,
IASTOR.CAT, and TXTSETUP.OEM files to a floppy diskette. Note: These files should be in
the root directory of the floppy.
Note
Any spaces in the pathname or filename require quotes around the
pathname or filename. The switches do not require quotes. For example:
“C:\My Documents\setup.exe” –A –P.