Uniden MC 800 Copier User Manual


 
!
i
i
J
I
I
I
I
!
j
-~ ---',--.,.c= -===
-
.....
Controls 'and Functions-Cont's
~ 14. Zoom - This control is used with the A, V, and Reset
keys to set the Zoom range. To initiate this mode, press the Zoom
key once, and the vertical zoom cursor will appear on the right side
of the screen. Set the desired Zoom range by moving the cursor with
the A and v, then press the Zoom key again. The Zoom range scales
appear with a digital numeric display, Zoom mode starts, and an
expanded (zoomed) chart appears over the whole of the screen. The
Zoom range is normally set to 15 feet, but can be changed in 1 foot
increments. You can also change the Zoom setting while in the Zoom
mode by pressing the Zoom key, and then either the A or V keys to
change the Zoom position.
~ 15. Digital Display Mode - This control is used to turn the
Digital Display Mode on or off. When you first turn the unit on, the
display will show the normal chart display mode. Press the DDM
button once to give you a large Digital Depth and Water Temperature
display. Press the DDM or AUTO buttons to return to normal chart
display mode. While in DDM, all functions except AUTO and LIGHT
are disabled.
16. Key Press Timing - In case you did not press a sub-
key within 5 seconds after you pressed a function key, the keying is
cancelled with a short beep tone. -
-4-
-r
-'--" -- "n._-'- .. ---' ---,,_"':c,:,c~l' '