Filter
Top Products
11
Introduction
12 SEARCH/AM - In Scanner mode press to start a Limit Search or to resume
searching. In AM/FM mode, press to select the AM memory bank.
In Service mode, press to select the POLICE service.
13 L/O FM1
- In Scanner mode, press to lock or unlock a channel memory in
SCAN (HOLD) or PROGRAM mode.
In Search mode, press to set or clear a selected frequency previously locked
out in the LIMIT SEARCH or SERVICE SEARCH (Hold) mode. In AM/FM
mode, press to select the FM1 memory bank.
In Service mode, press to select the MARINE service.
14 DELAY/FM2
- In Scanner mode, press to turn the delay option on/off. In AM/
FM mode, press to select the FM2 memory bank.
In Service mode, press to select the RAIL ROAD service.
15 PRI/MEM
- In Scanner mode, press to set a Priority channel for Scan Hold
mode and Program mode.
In Service mode, press to select AM CB service.
In Program mode, press to set the Priority channel setting. In SCAN and
SCAN HOLD, press to set Priority Scan on or off.
In AM/FM mode, press to select Memory Mode to allow quick channel recall
using the 0-9 keys.
16 SVC/DIR
- In Scanner mode press to change to Service Search mode.
In AM/FM mode, press to change to Direct Entry mode to allow channel
frequency selection using the up / down arrows or 0-9 keys.
In Service mode, press to select the UHF CB service.
17 MODE
Switch - Use to select the desired mode: AM/FM; Air; Scanner. (TIME
switch must be set to Clock)
18 t - Press and release to move down through channel numbers in the
following HOLD modes: SCAN, PROGRAM, SERVICE SEARCH, and AIR
or the step frequency in LIMIT SEARCH, and AM/FM mode. (refer to the
frequency and step table on page 6)
Press and hold for more than 1 second to have the changes run continuously.
19 s - Press and release to move up through channel numbers in the following
HOLD modes: SCAN, PROGRAM, SERVICE SEARCH, and AIR or the step
frequency in LIMIT SEARCH, and AM/FM mode. (refer to the frequency and
step table on page 6)
Press and hold for more than 1 second to have the changes run continuously.
20 HEADPHONE Jack
- lets you use an headphone for private listening.
21 Antenna Connector
- connect an external antenna using a BNC connector.
AM RADIO ANT connector - connect the supplied loop antenna and position it
for best AM Broadcast radio reception.
UBC340CRS OM.indd 11 7/5/08 4:28:09 PM