Filter
Top Products
13
Setting Up The Scanner
Setting Up The Scanner
These guidelines will help you install and use your new scanner:
If your scanner receives interference or electrical noise, move the
scanner or its antenna away from the source. You might also try
changing the height or angle of the antennas.
Use an optional mono earphone or mono headset with proper
impedance for private listening.
Do not use the scanner in high-moisture environments such as in the
kitchen or bathroom.
Avoid placing the scanner in direct sunlight or near heating elements
or vents.
Connecting Power
Insert the supplied AC
Adapter’s barrel plug into the
power jack on the back of the
scanner. Then plug the Adapter
into a standard household outlet
that supplies 240V AC, 50Hz.
Do not plug the adapter into a
switch controlled outlet.
Open the battery compartment
and insert 3 AA batteries.
Be sure to note the polarity markings in
the battery compartment. You can use
either alkaline or rechargeable batteries,
but the scanner will not recharge
batteries in the compartment.
• Use only fresh alkaline AA batteries.
Rechargeable batteries can be used,
but battery life is shorter than with
alkaline batteries.
• Always remove old or weak batteries.
Batteries can leak chemicals that
destroy electronic circuits.
• Do not mix old and new batteries,
different types of batteries (standard,
alkaline, or rechargeable) or rechargeable batteries of different
capacities.
•
•
•
•
•
•
240
Model AAD-008S
UBC340CRS OM.indd 13 7/5/08 4:28:11 PM